How to size a cuff
1. Measure below the wrist bone using a flexible measuring tape or a strip of paper. Make sure your measuring tape or strip of paper is not too tight on your wrist.
2. If using a plain strip of paper, mark your strip with a pen where the end of the cuff needs to be. Then measure the paper strip with a ruler. This is the TOTAL SIZE of your wrist.
3. Cuffs are sized by taking the actual skin measurement minus 3/4" or an inch. For example a size 5.25 cuff fits a wrist measuring 61/4". If the skin measurement is 7" or more, allow an inch opening.

How to put on a cuff 
A cuff should not ‘roll’ around on your wrist, if it does it is too loose.
You should not see your skin hanging over the edge, this means the cuff is too tight.
Putting on a cuff can seem tricky, find a soft spot with palms up, about 2" above the wrist bone.
This is typically the narrowest part. Press one end of the cuff into the soft spot and roll away from the body onto the wrist.
To remove, bring the cuff up above the wrist bone, find the soft spot and roll off.

How to size a ring 
1. Find an existing ring that fits your desired finger.
2. Measure the internal diameter of the ring (in mm).
3. Use the circle method to determine your rings size.

For Ring Re-sizing
1. Please send us an email if you need your purchased ring to go up or down in size. Please call for pricing. 
2. Ring resizing can take 4-6 weeks, and we try to accommodate any specific date.
3. Most rings can not be resized more than 3 half sizes larger or smaller.
4. Some designs, especially bands, can not be sized. In this case, it would need to be reordered in the requested size if not available in stock.

Any questions, please contact or call 505-919-7967

61 Old Santa Fe Trail

Santa Fe NM 87501